Mipro ACT 51(6A) Guia do Utilizador descarregar pdf (Página 10)

SQUELCH setting

Blinking SQ cursor

1 2

6 7 8

MHz

GRP

BAT

ACT

Press Once

Press once to increase

by one level

Press once to decrease

by one level

Instructions:

1. Press and release the button once. The ----SQ---- cursor starts blinking to

denote it is ready to accept parameter changes.

2. During blinking, press or button to decrease or increase sensitivity level

by 1 indicator.

3. Press and release the button once to confirm the change. The ----SQ----

cursor stops blinking and the new squelch level is now stored into memory.

NOTE: The higher the level indicators, the lower the sensitivity which shortens the

transmission ranges. The lower the level indicators, the higher the sensitivity which

increases the transmission ranges.

To exit SQ mode:

1. SQ mode deactivates automatically if or button is not pressed within 5

seconds. The VFD panel dims automatically, too.

Diversity Receivers Diversity Receivers

To Activate:

! Press and release button on the receiver to activate the ACT mode. Once

activated, the RF meter cursor and working frequency on the receiver start blinking.

Blinking will stop when IR signal is received by the handheld or boydpack

transmitter or no IR signal is received within 5 seconds.

To Cancel:

! During blinking, press and release the button again on the receiver to cancel.

! During blinking, do not press any button. Blinking stops and cancels automatically

after 10 seconds if no button is pressed.

ACT

SETTING ACT TRANSMITTER FREQUENCY

Instructions:

1. Ensure a receiver channel is set up and transmitter batteries are fresh, installed

correctly and powered-on.

2. Press the button on the receiver to activate the ACT function. Once activated,

the RF meter cursor and working frequency start blinking.

3. Bring ACT handheld or bodypack transmitter within 30cm (12”) of the IR port on

the receiver. The IR port is located between the and buttons and

indicated by a round-shaped red color spot. The frequency will sync automatically.

4. When the frequencies are synchronized successfully the RF meter cursor and

working frequency stop blinking and the indicators in the RF meter are lit.

ACT

1 2

7 8

MHz

GRP

BAT

CHANNE L 1

1 2

7 8

MH z

GRP

BAT

CHANN EL 1

< 3

)

1 2 ... 5 6 7 8 9 10 11

Comentários a estes Manuais

Sem comentários

Mipro ACT 51(6A) Guia do Utilizador Página 10

Comentários a estes Manuais

Manuais e produtos relacionados com Recetores de rádio Mipro ACT 51(6A)